Dado cutting is a very popular wood cutting. If you are thinking to start a dado cut with your table saw then you have to use a dado blade in your table saw. Now, a question that may come to your mind that is; Can All Table Saws Use Dado Blades? Is your table saw capable of cutting dado? Or, Can I fit a dado blade to my table saw?
You should read this full article to remove this confusion.
When a person is searching about dado cutting blade or table saw then I am sure he is a professional woodworker. Because dado cuts are done in the workshop.
At first, you have to pick a table saw that accepts the dado blade and there are proper guidelines to know what table saw accepts the dado blade and which type of blade you will pick for the dado cutting.
Can All Table Saws Use Dado Blades?
If you are thinking that you can adjust a dado blade in any table saw then you are wrong. First of all, you have to buy a dado blade if you did not get any dado blade with your saw.
But, you should ensure that, can you fit a dado blade to your table saw? If your table saw cannot accept a dado blade then you will not be able to do dado cutting with your table saw.
You have to use a small blade for dado cutting. For example, your table saw accepts a 13-14 inch blade. Now you have to use an 8 -10 inch blade for dado cutting.
On the other hand, if you have a small table saw and you wanna cut dado then you should use a small blade that is smaller than your original blade size.
There is another way to dado cut without change your original blade. You just make lower your blade in the lowest point. Then the blade will go down and it will be perfect for dado cut.
Can Hercules table saw use dado blades?
Yes, a Hercules table saw use dado blades if you maintain the roles that I mentioned above. The Dewalt, Ryobi, Skill, and Hercules hob site table saws are really perfect for dado cutting. Maximum of users use this table saw for their professional long time projects.
How do you adjust a dado blade?
You are ensured that your table saw accepts a dado blade or you have picked a dado cutting table saw then your next important is blade adjusting.
First, remove the blade guard and reach the blade at the highest point. It is not difficult to adjust a dado blade in your table saw. Use a perfect wrench that is the accurate size on your table saw blade’s nut. The blade has two nuts on either side. You need to take two wrenches to remove the blade. Hold the inner nut with a wrench and open the outer one with the upper wrench.
You just need to open the screw of the original blade and take the small dado blade in your hand.
You should do this work very carefully. If it is possible you can wear hand gloves so that you will not be injured from the blade teeth. A dado blade is very dangerous!
After removing your old blade you need to put your new blade or dado blade in the blade nut. Now, tide the nut again however you have removed the old blade. And, don’t forget to tide the screw with a double wrench.
All table saws not accept the dado blade. Don’t mistake buying a dado cutting table saw when you will buy a table saw.
Finally, I want to say that you should work very carefully. Because you can be injured by a table saw. It is the best solution to stay safe if you use all safety equipment to using a table saw. (You must need to know about sable saw safety). Thank you…